Kegco K309SS-2HB - Manual (Page 6)

www.kegco.com 6 1-800-710-9939
Setting Temperature
The Kegco Kegerator is able to maintain the proper dispensing temperature for beer, provided it is installed correctly in
the proper environment. For best results, mount the draft tower as close to the top of the kegerator as possible and
seal any openings to prevent heat transfer. Avoid opening and closing the door of the kegerator too often to ensure a
consistent temperature inside the unit. Beer is dispensed best between 32°F - 38°F. If it is kept below or above that
range, you may experience foam issues.
You can set the temperature as you desire by touching the Cooler or Warmer button. When you touch the buttons for
the first time, the LED readout will show the original temperature set at the manufacturing facility. Each push of the
button will adjust the temperature by one degree in the desired direction. Please be aware that the desired
temperatures may fluctuate depending on the ambient temperature and the orientation of the keg.
PLEASE NOTE:

In the event of a power interruption, all previous temperature settings will be automatically saved and the unit
will return to the previous temperature setting.

If the unit is unplugged, loses power, or is turned off, you must wait 3 to 5 minutes before restarting. Attempting
to restart the kegerator before this time has elapsed may prevent it from starting.

When you use the kegerator for the first time or restart it after having been shut off for a long time, there will
be a few degrees variance between the temperature you select and the one indicated on the LED readout for
the first few hours of operation. After a few hours of operation, the temperature will normalize to the displayed
temperature.
NOTE: Keep a thermometer handy and adjust temperature control setting as necessary according to your needs.
Care and Maintenance
Cleaning your kegerator:

Turn off the power, unplug the appliance, and remove all items including the dispense kit.

Wash the inside surfaces with warm water and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.

Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.

Wash the outside cabinet with warm water and mild liquid detergent. Rinse and wipe dry with a clean soft cloth.

Do not use steel wool or a steel brush on the stainless steel. These will contaminate the stainless steel with steel
particles and rusting may occur.

Dust the front grill and back of the unit twice yearly. Make sure the power is off before cleaning.

It is recommended to clean the unit completely inside and out yearly to maximize the longevity of the product.
Moving Your kegerator:

The provided casters will allow you to roll the appliance from one location to another in your home easily.

For transportation, remove the keg, the dispense kit and any other items you may have inside the unit.

Securely tape down all loose items inside your appliance and tape the door shut.

Be sure the appliance stays secure in the upright position during transportation.

Protect the outside of the appliance with a blanket or similar item.