Advanced Technology MirroFlex Structures - Manual (Page 6)

ATI-MFFII Revision 2 Effective Date: 8/5/12
Advanced Technology, Inc (800) 849-1320 www.advtechnology.com
Page 6 of 6
4’ x 8’ Wall Panels
1. Before starting the installation, surface must be dry, smooth and free from dust, grease, wax,
and other particles*.
1. Measure the area to be covered to determine how many panels you will need.
2. MirroFlex wall panels should be installed from left to right, making sure the small flats of the
panel are to the top and right (if your panel has Built-in-Overlap or BIO). After applying your
selected adhesive to the wall, according to manufacturer’s instructions, lay up your first tile
applying pressure as you hold it (if your panel came with protective masking, gently remove it
now). Make sure the panel is straight before you continue with the next one.
3. Repeat this process, working left to right (removing the protective masking after installing each
panel, if your tile came with masking). When finished, use the paint roller on an extension pole
to apply additional pressure to the wall.
* The method you choose for cleaning prior to application must be compatible with the surface you are cleaning
(e.g. denatured alcohol, degreaser, soap & water, TSP, Greased Lightning, etc.). Check the manufacturer’s label
directions for instructions on using the product.
Outlet Covers
1. Some outlet covers (simple, inexpensive) can be covered with matching covers. To do this, peel
the backing off of the outlet cover piece and lay flat, placing the sticky side up. Place the outlet
cover centered and face down on the adhesive sheet. Using a utility knife, cut a square away
from each corner. Fold the edge of the adhesive sheet over the outlet cover to create a
seamless finish. Turn the cover over, and use a utility knife to carefully cut away the outlet
openings.
Installation Videos
MirroFlex Structures Installation Videos can be found on our website at
www.advtechnology.com/how-to-install
Conditions & Warranty
Advanced Technology, Inc. believes all information contained herein to be correct. It is the
responsibility of the fabricator/customer to completely test the adhesives and methods of fabrication to
ensure that the results are satisfactory. ATI is not responsible for any fabrication or ancillary costs
involved with using MirroFlex products.
All shipments are to be inspected within 10 working days after delivery. We are to be informed in writing
of any potential adjustment necessary. The seller’s only obligation will be to replace defective sheets on
a one to one basis. Neither the manufacturer nor the seller shall be liable for any additional damage or
loss, directly or indirectly, arising as a result of using MirroFlex products.
Slight imperfections and color variations from sheet to sheet are possible and considered normal.
Please inspect each sheet carefully before fabrication to ensure it meets your needs.
Visit us online at advtechnology.com for the latest patterns and finishes.