Beijer Electronics iX T7AM EN - Manual (Page 4)

Safety Precautions
1 Safety Precautions
Both the installer and the owner and/or operator of the operator panel must read
and understand this installation manual.
1.1 UL and cUL Installation
• This equipment is suitable for use in Class 2 non-hazardous locations only.
[Combinations of equipment in your system are subject to investigation by
the local Authority Having Jurisdiction at the time of installation].
• All devices have to be supplied by a Class 2 power supply.
Warning:
Do not disconnect equipment unless power has been removed or the area is
known to be non-hazardous
• For Canada also AVERTISSEMENT – AVANT DE DECONNECTER
L’EQUIPEMENT, COUPER LE COURANT OUS’ASSURER QUE
L‘EMPLACEMENT EST DESIGNE NON DANGEREUX.
Warning:
Only UL and cUL approved expansion units are allowed to be connected to
the port designated “EXPANSION”. At the moment there are no such units
evaluated or allowed
Warning:
Do not replace expansion unit unless power has been switched off or the area
is known to be non-hazardous.
• This product contains a battery; this must only be changed in an area known
to be non-hazardous.
–
Replace Battery with Seiko Instruments or similar, Part No. MS920SE.
Use of another battery may present a risk of fire or explosion. See owner's
manual for safety instructions.
Warning:
Battery may explode if mistreated. Do not recharge, disassemble or dispose
of in fire.
• For use on a flat surface of a type 4X enclosure indoor use only.
• Use 75 degree conductors only
• Use copper conductors only
Beijer Electronics, MAEN118A 4