Beijer Electronics CAN J1939 EN - Manual (Page 2)

Installation of Expansion Module for CAN J1939
The expansion module is used for the operator panel to communicate via CAN
J1939. The correct driver must be installed in the operator panel.
Important
Read the entire installation instructions prior to installing and using this equip-
ment. Only qualified personnel may install, operate or repair this equipment.
Users must acquire the appropriate knowledge to use the equipment properly.
The manufacturer does not assume any responsibility for modified, altered or
renovated equipment.
THE MANUFACTURER SHALL NOT BE LIABLE TO ANYONE FOR
ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUEN-
TAL DAMAGES RESULTING FROM THE INSTALLATION, USE OR RE-
PAIR OF THIS EQUIPMENT, WHETHER ARISING IN TORT,
CONTRACT, OR OTHERWISE. BUYER’S SOLE REMEDY SHALL BE
THE REPAIR, REPLACEMENT, OR REFUND OF PURCHASE PRICE,
AND THE CHOICE OF THE APPLICABLE REMEDY SHALL BE AT
THE SOLE DISCRETION OF THE MANUFACTURER.
Technical Data
Space Requirements
Installation
1. Unpack and check the delivery. If damage is found, notify the supplier.
2. Disconnect the operator panel from the power supply.
3. Remove the plastic cover from the expansion port.
4. Secure the expansion module in position, using the provided screws.
5. Connect the operator panel to the power supply.
Attention:
Observe precautions for handling electrostatic sensitive devices.
Size, W x H x D 87 x 70 x 30 mm
Weight 0.12 kg
Note:
Place the panel on a stable surface during installation. Dropping it or letting it fall
may cause damage.
30 mm
70 mm
M3x6 - 4 pcs
Installation of Expansion Module for CAN J1939 Installation of Expansion Module for CAN J1939