Beijer Electronics iX Panel T40 EN - Manual (Page 21)

Hardware Replacement
7.3 Replacing the Rear Cover
The following is needed:
• A new rear cover, see Available Spare Parts for iX Panel T40
• A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the rear cover:
1. Power off the operator panel.
2. Follow the
Replacing the Battery instructions to remove the battery.
3. Remove the rear cover of the operator panel by loosening the 4 torx screws.
4 x torx screws
4. Re-assemble with the new rear cover in reverse order.
Beijer Electronics, MAEN004 21