Beijer Electronics iX Panel T40 EN - Manual (Page 22)

Hardware Replacement
7.4 Replacing the Display/Display
Cable
The following is needed:
• A new display including display frame, see
Available Spare Parts for iX Panel T40
• A torx T10 screwdriver
• Two plain screwdrivers
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the display/display cable:
1. Power off the operator panel.
2. Follow the instructions under
Replacing the Rear Cover to remove the rear
cover.
3. Unlock the flex cable connector by pressing the connector flanges towards the
cable and disconnect the flex cable and the plain cable from the power card.
The connector must be unlocked on both sides before removing the cables.
power card
flex cable
plain cable
4. Gently press the power card towards the top of the panel as shown in the
illustration above to release the power card from the power card holders. Then
tilt the bottom of the card away from you.
5. Disconnect the flex cable on the back side of the power card and remove the
power card.
Beijer Electronics, MAEN004 22