Beijer Electronics iX Panel TA100 EN - Manual (Page 42)

Software
Requirements
Upgrading of the operator panel system program requires the following:
• A PC
• An Ethernet connection between the PC and the operator panel or an empty
USB memory stick.
• The Image Loader executable file from the web site
Upgrading the System Program Using a USB Memory
Stick
When upgrading the system program using a memory stick, you can select to
delete or to keep the project in the operator panel.
Follow the steps below:
1. Connect an empty USB memory stick to your PC.
2. Double-click on the executable Image Loader file.
3. Select the drive of the desired USB stick and click Create.
The files are copied to the USB stick.
4. Connect the USB memory stick to the operator panel.
5. Cycle the power to initiate the upgrade.
Upgrading the System Program via Ethernet
When upgrading the system program via Ethernet, the project in the operator
panel is retained.
Follow the steps below:
1. Make sure that your PC and the operator panel are connected via Ethernet.
2. Double-click on the executable Image Loader file.
3. Enter the IP address of the operator panel.
4. Click Update, and follow the instructions.
The files are transferred to the operator panel. The panel will reboot
automatically when the transfer is finished.
Beijer Electronics, MAEN013A 42