Fagor REIN-652I - Manual (Page 20)

f
620 mm.
155 mm. 155 mm.
40 mm.
distancia (d)
20
Mark the hole positions: Take
into account the distance from the
fl oor (620 mm) and the distance
between the fi xing parts, depen-
ding on the model.
Fixing parts: To fi x the appliance
to the wall, use the two fi xing clips
supplied. At the rear of the Eco-
heater there are two grooves for
these fi xing clips to be fi tted into.
Drill suitable holes: Insert the
Ø6 mm rawl plugs supplied with
the fi xing kit, position the fi xing
clips and tighten the screws until
the clips are suffi ciently secured.
Level the clips in the elongated
holes until they are at the same
height, then fi
rmly tighten the
screws.
Before fi xing the appliance to the
wall, you should fi rst fi x in place
two stops, which are contained
in the fi xing kit. Turn the Eco-
Heater face down. On the lower
rear part of the Eco-Heater there
are two threaded holes for these
stops to be screwed into using 2
screws (Ø 2.9 x 9.5). Position the
stops as shown in the diagram
and screw in the screws until the
stops are correctly fi xed to the
appliance.
b
c
d/e
f
636 W 150 mm
954 W 300 mm
1272 W 450 mm
1590 W 600 mm
model distance (d)
Hang the appliance from the top fi xing clips.
Check the appliance is securely fi xed in place.
b
c
e
d
f
In cases where use of the wall support is not possible, support
feet are available that are attached to both the device and the
fl oor as follows:
3.2 Floor attachment accessory INNOVATION