MIPRO ACT-71 Wideband Single-Channel True Diversity Receiver - Manual (Page 5)

Rear Panel:
True Diversity Receivers True Diversity Receivers
4 5
ACT-71 Single-Channel True-Diversity Receiver
6 10 8 11 12 14 13 15
ACT-72 Dual-Channel True-Diversity Receiver
6 7 8 9 10 12 13 14
12 13 14
ACT-74 Four-Channel True-Diversity Receiver
6 7 8 9 10
Rear Antenna “B” Input Connector: The “B” antenna can be installed directly to
this antenna connector which also provides power to an optional antenna booster.
Ventilation Fan: Ensures stable performance in long hours of operation under high
temperature environments.
Level Switch: "0dB" selection is for "Microphone level" output. "+16dB" selection is
for “LINE level” output. “-6dB” selection is for half of cable microphone volume.
Mixed AF Output Jack: A balanced output jack for mixed AF signals from all
installed channels; 3 output levels to choose from.
Balanced Audio Output Jack: XLR type connector provides balanced audio
output signal from this jack to the mixer, and output level is selectable from among 3
levels: “-6dB”, “0dB” and “+16dB”.
8
10
6
7
9
16
CH 1 CH 2 MIXED
ANTENNA A +8V DC BIAS ANTENNA B +8V DC BIAS REMOTE
OUT IN
3: COLD - 1: GND + 2: HOT 3 2 1 LEVEL This connector can not be connected
to telecommunication networks.
BALANCED OUT AC INPUT: 100~240V
-6dB 0dB
GND
LIFT
+16dB
CH 1 CH 2 CH 3 CH 4 MIXED
REMOTE ANTENNA A +8V DC BIAS ANTENNA B +8V DC BIAS OUT IN
3: COLD - 1: GND + 2: HOT 3 2 1 LEVEL This connector can not be connected
to telecommunication networks.
BALANCED OUT AC INPUT: 100~240V
-6dB 0dB
GND LIFT
+16dB
16
16
Unbalanced Audio Output Jack: ¼” PHONE PLUG type connector provides
unbalanced audio output signal from this jack to the mixer (ACT-71 only).
Output level is selectable from among 3 levels: “-6dB”, “0dB” and +10dB (the switch
will show +16dB on the receiver, but actually puts out +10dB on the unbalanced
jack).
Network Interface Connector: For linking the receivers to a computer system-
monitoring program.
Rear Antenna “A” Input Connector: The A antenna can be installed directly to this
antenna connector which also provides power to an optional antenna booster.
AC Power Socket: The input socket for AC power ranging from 100VAC ~ 240VAC.
Rack-Mount Brackets: To install the receiver into a standard EIA 19-inch rack case.
LIFT/GND Switch: Lifts ground from Pin 1 of the XLR connector. (GND = default).
14
13
12
11
15
16