MIPRO ACT-71 Wideband Single-Channel True Diversity Receiver - Manual (Page 9)

NOTE: To confirm a parameter change and save it into the system, you must press the
button to end the flashing of the cursor. If this step is missing, the new parameter is
not saved and will not be stored in the system when powered off.
Receiver Parameters
True Diversity Receivers True Diversity Receivers
12 13
Rotary Control Knob: To set parameter values
6 parameters can be selected and programmed. See instructions below:
Programmable Parameters:
GROUP setting
SET
SELECT
GRP Cursor
4
Instructions:
1. Press and release the button once. The cursor starts flashing to denote
it is ready to accept parameter changes.
2. Turn Rotary Controller left or right and stop at . Press and release the Rotary
Controller once and current number starts flashing.
3. Turn Rotary Controller left or right to increase or decrease numbers.
4. Press and release the Rotary Controller once to confirm the change. The
number stops flashing.
5. To confirm and save the new parameter, press and release the button once.
The cursor stops flashing and the new GRP number is now stored into
memory.
4
4
4
4
Turn knob clockwise to increase values
Turn knob counterclockwise to decrease values
GRP
GRP
GRP
GRP
GRP
GRP CH FRQ NAME ADD SQ