MIPRO ACT-717 Single-Channel True Diversity Receiver - Manual (Page 10)

SET
SELECT
CH Cursor
True Diversity Receivers True Diversity Receivers
14 15
Turn knob clockwise to auto scan
from beginning to the end of frequency band
Turn knob counterclockwise to auto scan
from end to the beginning of frequency band
SET
SELECT
FRQ Cursor Turn knob clockwise to increase frequency
Turn knob counterclockwise to decrease frequency
Instructions:
4 4
CHANNEL setting CH
Instructions:
1. Press and release the button once. The cursor starts flashing to
denote it is ready to accept parameter changes.
2. Turn Rotary Controller left or right and stop at . Press and release the Rotary
Controller once and current number starts flashing.
3. Turn Rotary Controller left or right to increase or decrease numbers. If there
is interference on your chosen CH, it will automatically jump to the next
interference-free CH.
4. Press and release the Rotary Controller once to confirm the change. The
number stops flashing.
5. To confirm and save the new parameter, press and release the button once.
The cursor stops flashing and the new number is now stored into
memory.
4
4
4
4
CH
CH
CH
CH
CH
FREQUENCY setting FRQ
1. Press and release the button once. The cursor starts flashing to
denote it is ready to accept parameter changes.
2. Turn Rotary Controller left or right and stop at . Press and release the Rotary
Controller once and the current number starts flashing.
3. Turn Rotary Controlle left or right to increase or decrease numbers in
increments of 1MHz (first 3 digits of the frequency #).
4. Press and release the Rotary Controller again to confirm the first 3 digits, then
turn left or right to adjust the last 3 digits of the number in increments of 25
KHz.
5. Press and release the Rotary Controller once more to confirm the change. The
number stops flashing.
6. To confirm and save the new parameter, press and release the button once.
The cursor stops flashing and the new number is now stored into
memory. If the new frequency is not one of the preset channels for that Group, the
display will show asterisks in place of the Group and Channel designations.
NOTE: If a new frequency is selected that is not among the preset channels for the
chosen Group, it MAY not be compatible with the other channels within that Group
and may potentially cause interference. If this occurs, the frequency will need to be
changed to avoid problems. The preset channels within each Group are specifically
selected to work together when using multiple systems simultaneously.
4
4
4
4
4
FRQ
FRQ
FRQ
FRQ
FRQ
FRQ