MIPRO ACT-717 Single-Channel True Diversity Receiver - Manual (Page 9)

SET
SELECT
GRP Cursor
4
Turn knob clockwise to increase values
Turn knob counterclockwise to decrease values
GROUP setting GRP
Instructions:
1. Press and release the button once. The cursor starts flashing to
denote it is ready to accept parameter changes.
2. Turn Rotary Controller left or right and stop at . Press and release the
Rotary Controller once and current number starts flashing.
3. Turn Rotary Controller left or right to increase or decrease numbers.
4. Press and release the Rotary Controller once to confirm the change. The
number stops flashing.
5. To confirm and save the new parameter, press and release the button once.
The cursor stops flashing and the new GRP number is now stored into
memory.
4
4
4
4
GRP
GRP
GRP
GRP
NOTE: To confirm a parameter change and save it into the system, you must press the
, button to end the flashing of the cursor. If this step is missing,
the new parameter is not saved and will not be stored in the system when
powered off.
Receiver Parameters
Rotary Control Knob: To set parameter values
6 parameters can be selected and programmed. See instructions below:
Programmable Parameters:
GRP CH FRQ NAME ADD SQ
True Diversity Receivers True Diversity Receivers
12 13