Rhin-O-Tuff HC8024 - Manual (Page 4)

Book Preparation:
Assemble your punched book
completely with covers on the top and
bottom if required. Stand the book up with
the binding edge toward the left
and the
front of the book facing you.
Pull from the back of
the book. Flip the page over putting the
binding edges back together
.
Flip the entire book over and place
flat with the covers on the bottom . This
configuration will position the wire binding
seam on the inside of the back cover of the
book when complete.
①
the rear cover
②
③
4
HD8000 Setup:
The HD8000 comes with the handle attached to the right side of the machine.
The handle can be removed and re-attached with the handle facing away from the
machine or it can be attached to the left side of the machine to suit operator needs. If
the handle is changed from its original position make sure to retighten the handle bolt
securely to ensure proper operation of the handle.
The HD8000 has a reversible top closing plate. To reverse the plate, remove the
three small knobs (Fig. 2) from the top of the closing bar and remove the plate from
underneath.
To install plate, hold plate under the top closing bar and install the three small
knobs.
Fig. 1
Fig. 2