Rhin-O-Tuff HC8024 - Manual (Page 7)

Closing the Wire:
Return handle to the full upright position, place the book so the open mouth of
the wire is firmly pressed against the back plate inside the closing machine. The
narrow, open loop of the wire should be on top of the book while pushing against the
back plate , with the wire seam on the bottom.
Apply enough pressure on the book so that the wire stays in contact with the
back of the machine as you pull the handle down to the position set in the previous
section. Return handle to upright position and inspect the close of the wire in your
book, re-adjust the closing bar if necessary. When the wire is closed properly, the
narrow, open loops overlap the wide loops by about 1/32 inch along the entire length of
the book. An indication that the book is not closed correctly is when pages fall out of
the book.
Flip the back cover sheet back to the back of the book. Your book is complete.
①
②
①
7