Meteor ProMover P64 - Manual (Page 2)

2
NDSP: Inverted Digital readout - used while unit is mounted on truss or ceiling.
(if you are going to be looking at the LCD display while unit is hanging down – it is
recommended that you invert the LCD screen read out so you can look at it normal)
TALL: Test all channels of unit. If you want to test all channels. Press Enter.
(LCD changes to read – CH01 – press Enter. Channel 1 (lamp and fan channel) will
start to come up in brightness and the fans will increase in speed to cool fixture.
Press Black UP button. LCD changes to
CH02 . Press Enter. Lamp will start to flash and
strobe.
Press Black UP button. LCD changes to
CH03 . Press Enter. Fixture will run through it
full PAN capability.
Press Black UP button. LCD changes to
CH04 . Press Enter. Fixture will run through its
full TILT cycle.
Press Black UP button. LCD changes to
CH05 . Press Enter. Does fine adjust – PAN.
Press Black UP button. LCD changes to CH06 . Press Enter. Does fine adjust – TILT.
Press M/C Black button to exit this test mode.
TLMP: Time of usage on lamp. Press Enter. Fixture will start to come up and fans will increase
in speed for maximum cooling
RSET: Unit resets itself to factory settings. TEST
Press Enter
DEMO: Unit runs it programs in a demo mode. 3 options: O
OFF – Fixture to be controlled by lighting controller
SLAV – subordinate – daisy chained – inline with controller
AUTO – runs automatically
Press Enter
TEST: Specific channel you wish to test.
Press Enter.
Y DIR: Set either clockwise or counterclockwise response. Individual channel test runs
a full range of the Tilt Function (“Y” reverse) – Mirror image if need be.
Press Enter.
X DIR: Set either clockwise or counterclockwise. Individual channel test runs a full
range of the Pan Function (“X” reverse). Mirror image if need be.
Press Enter.
NDST
DISP
TALL
LAMP
NDST
DISP
TALL
LAMP
LAMP INSTALLATION: Replacing or installing the lamp.
- Disconnect Power from fixture. If lamp is broken, make sure no pieces of glass are rattling around
inside.
- On the back of the unit. Locate two (2) Spring clips. Push forward – the back will hinge open.
- Remove 8” retaining ring.
- Carefully insert Par 64 lamp of choice into / onto 4 long Teflon holders.
- Push lamp forward enough to the front brace.
- Position retaining clip back around the lamp to hold in place.
- Carefully plug the Ceramic lamp socket onto lamp. As far as it can.
Note: If not seated correctly, this could cause the socket to come loose from the lamp.
- Hold Back the two spring loaded clips and shut back of unit. Lock in place.
- Move unit head up and down to hear if there is any noise. If no noise, it is correctly seated.