Meteor ProMover P64 - Manual (Page 3)

3
SYSTEM SET-UP / OPERATION:
- Plug in 3-pin XLR cable into base of P64. Daisy chain from one unit to another if need be.
- Plug fixture(s) into 120v power mains.
- LCD Screen flashes INIT for a couple of seconds.
- Blue LED will light if the unit is receiving proper DMX. (No Blue LED, no DMX).
- Press M/C (Menu change / clear) button until you get to the ADDR screen. Press Enter.
- Set Base address by using either scroll “up” or “down” buttons. If you are doing this at the very beginning,
before you hang them, the arrow button aiming down is the scroll up button and the arrow facing up is the
channel down button. (When hung upside down, the buttons make complete sense). This can be changed
during initial setup.
- From the controller – gradually bring up Channel 1. Lamp will come on. Set lamp level / brightness to
desired setting.
- Position Pan and Tilt where you want them to be. Record that step.
- Repeat as often as need be for various fixtures.
SYSTEM INSPECTION: Prior to Installation
It is highly recommended that you do this procedure to test or check for individual Yoke motor speeds. This will ensure
that all heads are moving at the same speed.
- Unpack all Fixtures and put on a test bench. Set all Base addresses to Base address 1.
- Via DMX cable – From the controller connect ALL units. Move Pan and Tilt Channels to test speeds. If they
are exactly the same speeds. No need to change. If different:
- Press and Hold – MC. Display will change to ADDR.
- Press Up or Down Button until Display shows PERF. Press MC button again
- Display will read NOMA or MAX. Press MC again. Unit will go into I.N.I.T. mode (Reset)
MAX is faster speed. NOMA is regular speed. Regardless what you choose, make sure all units are set at the same –
NOMA (normal) or Max (fastest)
TECHNICAL SPECIFICATIONS:
Pan Rotation: 540 deg.
Tilt Rotation: 270 deg.
Weight: 22lbs (w/lamp)
Boxed wt.: 28lbs
Voltage: 120v – 60 Hz.
Base: 12” L x 6” w x 6 h
Base w/handles: 15” L
Yoke: 15” L x 4” w x 10” h
Par Housing: 9.5 L x 10” w x 10” h
Yoke w/ fixture: 14” high
Fuse: 10 amp
3 Pin XLR configuration
Pin 1 = Ground
Pin 2 = Data Negative
Pin 3 = Data Positive
(note) : Misprint on Screen - screen on base of unit reads incorrectly. It is standard USITT
configuration: 1- ground; 2- data negative and 3- data positive
MLSC, Inc.
P.O. Box 578, Madison, Al 35758
SHIPPING: 8000 MADISON PIKE, MADISON ALA. 35758. (256) 461-8000: FAX: (256) 461-7708
www.meteor-global.com www.meteor-usa.com e-mail: [email protected]