Magikitch'n LPCGA - Manual (Page 8)

4. MOUNTING the PROPANE TANKS in the TANK CART
(Figures 2 and 3)
A. Remove the front tank hold down bracket by unscrewing the wingnuts and lifting it from the studs.
B. Place the tank on it’s feet in the cart and slide the rear tank foot into the foot slot in the rear hold down
bracket.
C. Lower the front of the tank onto the floor of the cart so the front mounting foot rests over the tank stop.
D. Replace the front hold down bracket so that the front tank foot fits under the slot in the hold down
bracket.
E. Re-install the wingnuts on the studs and tighten them in place. Check the tanks for secure attachment
to the cart.
Caution: The tank cart will only accept 40-pound horizontal (all are clearly marked) DOT propane
cylinders. Never use a vertical tank in this or any horizontal system.
Front hold down
bracket
Wingnuts
Horizontal Tank
Front foot
Rear hold
down bracket
foot slot
Tank stop
Figure 3
Figure 2
5. HANGING the TANK CART on the CHARBROILER BASE
(Figures 4 to 7)
A. Lock all four casters on the base unit firmly so it doesn’t move during this operation.
B. Lift the fold-out handle at the front and raise the front of the tank cart so it will roll on it’s back wheels.
Back the cart under the front of the base unit, centering it between the caster legs.
C. Line up the two front hanging rings on the cart with the two long hooks on the front of the base unit and
hang the front rings of the cart onto the base hooks. Lower the front cart handle and fold it under.
D. Go to the rear of the charbroiler and raise the rear fold-out handle of the tank cart. Lift the rear of the
cart and slip the hanging rings onto the short hooks on the rear of the base unit. Lower the folding
handle. Check that the tank cart is solidly attached to the charbroiler base unit.
31-01-09819 L25-005 Rev 2 (05/11)
6