Amba Towel Warmers M Straight User Manual
Page 2
2 of 3
Step 5
Remove the cover plate and slide it to the back of
the wire cover tube. Now place the unit over the
tapered bushings installed in Step 4.
Securely hand-tighten each of the four set screws on
the bottom of the tubes.
Remove wire from slot in the end of the horizontal
tube. Position the wire from the rail and the wire from
the junction box to allow for connection. (Fig 5)
Splice the wires using the connectors provided and
place them inside the junction box. Cover the box
with the plate and secure with screws provided.
Step 6
The towel rails must be connected to either
an on/off switch (like a light switch) or a
7 day/24 hour programmable timer. (Fig 6)
Make sure one is provided for at installation.
The towel warmer will not perform if a timer
with a shorter cycle is used.
See wiring diagram below:
Please note: Due to the low
power requirements, and
the built-in thermostat which
maintains the unit at a safe
temperature, these units
can be left on all the time
without much energy
consumption. The longer the
unit is on the more
effectively it will perform.
Fig 6
Fig 5