Amba Towel Warmers M Straight - Manual (Page 3)

3 of 3
Safety Measures
1. Types of Safety Measures
1.1 Warning: States a hazard which may pose serious injury or death if exact installation instructions are not
followed.
1.2 Caution: States a hazard which may pose minor injury and/or product damage if installation instructions
are not followed.
1.3 Note: Helpful information which will facilitate installation.
2. Warnings:
2.1. These units should be installed by a certified electrician.
2.2. Follow these installation instructions carefully to ensure unit is properly attached to the wall.
2.3. To avoid a possible fire hazard, it is essential unit is mounted in accordance with guidelines stated in
these instruction.
2.4. Unit is intended for indoor use only.
2.5. Do not place units inside a shower, sauna, steam room, or wherever unit would be exposed to water.
2.6. Do not place unit where, if the mounting hardware were to loosen, it could potentially fall into water (i.e.,
a bathtub, whirlpool, etc.)
2.7. The unit must be installed in an upright position with the wire cover tube/junction box being positioned at
the bottom.
3. Cautions:
3.1. Ensure that unit is securely fixed to the wall. Unit is designed for drying towels. Under no circumstances
should anybody climb on or hang on unit.
3.2. The fasteners provided with the installation kit are for convenience only and are not suitable for all
installation conditions – it is the ultimate responsibility of the installer to ensure proper mounting
hardware is employed in attaching the unit to the wall.
3.3. Surface of unit is hot when on.
4. Care and Instructions:
4.1. Towels which contain soap or detergent residue may appear to have scorch marks; however, this is
simply discoloration of the residue in the towels themselves. The unit does not reach a temperature
sufficient to scorch towels.
4.2. Jeeves heated towel rails are constructed from 304 stainless steel. They are extremely durable. To
maintain a good appearance follow these simple care instructions:
4.2.1. For routine cleaning, simply switch off the unit, allow to cool to room temperature, wipe with a
damp cloth and buff with a soft, dry cloth.
4.2.2. Light scratches and blemishes may be removed by polishing the unit. Unit should be switched off
and allowed to cool, before polishing with a commercially available metal polish.
4.2.3. Under no circumstances should abrasive cleaners be used to clean the unit.
Contact us:
If you have any questions or comments please contacts us at:
Email: [email protected] Tel: 404-3509738 Fax: 404-3550166
Website: www.ambatowelwarmers.com
Warranty: Five year limited warranty, with proof of purchase, will apply if all Terms and Conditions of
Sale are met and Installation Instructions are adhered to.
Parts included with unit:
Allen wrench -1
Philips screws #8 x 2.5” - 4
Tapered Bushing (c) - 4
Slotted Bolts (b) - 4
Stainless Tube Assembly (a) -4
Marking Disc -1
Cover plate - 1
Screws for Cover plate -2
Wire Connectors suitable for 12-
16 AWG wire - 6
(b)
(c)
(a)
Loosen the set screw to release (c) from (a)