Amba Towel Warmers RWH-SB - Manual (Page 4)

Plug
R
A
D
I
A
N
T
P
L
U
G
I
N
1. Types of Safety Measures
1.1 Warning: States a hazard which may pose serious injury or death if exact installation instructions are not followed.
1.2 Caution: States a hazard which may pose minor injury and/or product damage if installation instructions are not followed.
1.3 Note: Helpful information which will facilitate installation.
2. Warnings:
2.1. These units should be installed by a certified electrician.
2.2. Follow these installation instructions carefully to ensure unit is properly attached to the wall.
2.3. To avoid a possible fire hazard, it is essential unit is mounted in accordance with guidelines stated in these instruction.
2.4. Unit is intended for indoor use only.
2.5. Do not place units inside a shower, sauna, steam room, or wherever unit would be exposed to water.
2.6. Do not place unit where, if the mounting hardware were to loosen, it could potentially fall into water (i.e., a bathtub, whirlpool, etc.)
3. Cautions:
3.1. Ensure that unit is securely fixed to the wall. Unit is designed for drying towels. Under no circumstances should anybody climb on or
hang on unit.
3.2. The fasteners provided with the installation kit are for convenience only and are not suitable for all installation conditions – it is the
ultimate responsibility of the installer to ensure proper mounting hardware is employed in attaching the unit to the wall.
3.3. Surface of unit is hot when on.
4. Care and Instructions:
4.1. Towels which contain soap or detergent residue may appear to have scorch marks; however, this is simply discoloration of the residue
in the towels themselves. The unit does not reach a temperature sufficient to scorch towels.
4.2. The heated towel rails are constructed from 304 stainless steel. They are extremely durable. To maintain a good appearance follow
these simple care instructions:
4.2.1. For routine cleaning, simply switch off the unit, allow to cool to room temperature, wipe with a damp cloth and buff with a
soft, dry cloth.
4.2.2. Light scratches and blemishes may be removed by polishing the unit. Unit should be switched off and allowed to cool, before
polishing with a commercially available metal polish.
4.2.3. Under no circumstances should abrasive cleaners be used to clean the unit.
Contact us:
If you have any questions or comments please contacts us at:
Email: [email protected] Tel: 404‐3509738 Fax: 404‐3550166
Website: www.ambaproducts.com
Warranty: Two year limited warranty, with proof of purchase, will apply if all Terms and Conditions of Sale are met and Installation
Instructions are adhered to.
Switch
FOR PLUG IN MODELS
THE UNIT IS SUPPLIED
WITH A cULus LISTED
CORD WITH GROUNDED
PLUG.
INSTALLATION IS THE
SAME AS THE HARD-
WIRED MODEL,
EXCLUDING:
STEPS 4, 10 AND 11.
THE UNIT MUST BE
PLUGGED INTO AN
OUTLET THAT IS
GROUNDED.
IMPORTANT: READ SAFETY MEASURES BELOW
Page 4
THIS INFORMATION
APPLIES TO THE
MODELS BELOW:
RWH-SB
RWH-SP
RWH-CB
RWH-CP
RWP-SB
RWP-SP
RWP-CB
RWP-CP
RWH - WALL MOUNTED
& HARDWIRED
RWP - WALL MOUNTED
& PLUG-IN
C - CURVED
S - STRAIGHT
B - BRUSHED
P - POLISHED