Minka Group F563-SP-BS/DW - Manual (Page 16)

8
NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or
removing the fuse at fuse box.
Step 1. Remove and discard the center plug from the switch cup. (Fig. 17)
Step 2. Feed the BLACK and WHITE wires from the light kit through the center hole of the switch cup.
Thread the switch cup to the nipple on the light kit. (Fig. 17) Make sure the light kit is securely
attached to the switch cup to prevent it from vibrating loose during fan operation.
Step 3. Carefully move the wires in the switch cup to the side to allow the lock washer and nut to be
threaded onto the nipple in light kit. Do not over tighten.
Step 4. Locate the WHITE and BLUE wires in the switch cup labeled "LIGHT", remove the wire nuts
attached to these wires. (Fig. 17)
Step 5. Proceed to make the wire connections as follows; Connect the WHITE wire from the switch
cup to the WHITE wire from the light kit, secure the connection with a wire nut previously removed.
Follow the same procedure for the BLUE wire from switch cup and BLACK wire from light kit. You may
wrap the connections with electrical tape for added safety. (Fig. 17)
Step 6. Carefully and neatly tuck the wire connections into the switch cup.
LIGHT KIT INSTALLATION
Fig 17
SWITCH HOUSING
ASSEMBLY
LOCK WASHER
NUT
LIGHT FIXTURE
SOCKET
CENTER
PLUG