Martin Universal Design U-DS14 BERKELEY TABLE - Manual

BERKELEY U-DS1400C ASSEMBLY INSTRUCTION
C. Plastic Knob
A. Stand Frame
D. Hex Bolt
E. Phillips Screw
1. Swing the left and right side legs out
as shown. See Fig. 1
Your new U-DS1400C Berkeley Table has been designed and manufactured to enhance your productivity and efficiency.
This sturdy folding table, properly assembled, will last through years of use. Follow the instructions below to assemble your
table and refer to the enclosed parts list for part identification. Tools needed for assembly: phillips screwdriver, hammer, nail
or awl, tape measure and pencil. Begin by unpacking the carton and making sure you have all parts listed.
2. Put the hex bolt [D] inside the clamp
(See Fig. 2) and then attach knob [C]
and tighten. (See Fig. 3)
Fig. 3
Fig. 2
Fig. 1
NOTE:
Make sure the collar
is in the correct posi-
tion as shown.
See Fig. 3
Martin Universal Design, Inc. • 4444 Lawton Avenue, Detroit, MI 48208 USA
Tel: (313)895-0700 / Fax:(313)895-0709 • E-mail: [email protected]
Brackets
ONE YEAR GUARANTEE
This Martin Universal Design, Inc. product has a one year guarantee
to be free from manufacturers defects during that period of use by the
original purchaser. Items or parts subjected to extreme temperature or
abuse or use of this product other than manufacturers intended purpose
is not covered under this guarantee.
B. Metal Guides
STOP
PLEASE DO NOT RETURN THIS TABLE to the
Store where you purchased it. If you are unable
to assemble or parts are missing, PLEASE Call
Customer Service at
Martin Universal Design, Inc.
313-895-0700 or Email: [email protected]
Any Questions with Assembly? We Can Help
ITEM# PARTS LIST QTY
97-DS140A A. Stand Frame 1
97-DS140B B. Metal Guide 2
97-DS140C C. Plastic Knob 4
97-DS140D D. Hex Bolt 4
97-DS140E E. Phillips Screw 14
84-2100C 30 x 42 White Top 1
Created 06/06 RPI