Martin Universal Design U-UDS5000WD Drawing Table - Manual (Page 4)

4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: [email protected] • visit us at www.MartinUniversalDesign.com
Pg. 4
STEP 5] Table Adjustments
To Raise or Lower the height of the table, loosen the Lower knobs found on the channeled Base supports. Raise or Lower
the table to your desired position and re-tighten the knobs to secure. See illustration below.
To Adjust the tilt of your table, loosen the knobs found on the tilt brackets. Loosen and change the tilt of the table top, re-
tighten once desired tilt is achieved. See illustration below.
If your table seems like it is uneven due to an un-even floor. Loosen or tighten each rubber foot until the table sits evenly
on the surface. See illustration below.
NOTE: The back of the table has a convenient Book Shelf/Ledge which holds books and magazines.
ENJOY your new MXZ Drawing Table!
Aug. 08 Revised- RPI
U-UDS5000WD Drawing Table Assembly Instructions
IMPORTANT: ASSEMBLY IS EASIER AND SAFER WITH TWO PEOPLE
These lower knobs
are for table
height adjustment
These upper knobs
are for table
tilt adjustment
The Rubber Feet
can be adjusted for
uneven floors.
The back of the table has a convenient
Book Shelf/Ledge which holds books
and magazines.