Martin Universal Design U-DS92STB Ashley Table with Stool - Manual (Page 4)

Step 4: Collars
Step 5: Upper Base Ends
Step 6: Drawer Supports
Loosen the lower bolt below the knob on the collar. Line up
the square end with the base.
Slide/push on top of the base. It is beneficial to have the
knobs face inwards so they do not interfere with drawers or
Media supports.
Now tighten the lower bolt to make snug (being careful
not to over tighten)
Take each Upper Base End (Part ) so the holes face the
front of the desk.
Assemble by inserting the ends of the Upper Base Ends into
the [4] collars (Part ) on top of the base assembly.
Tighten knobs on collars to secure
(careful not to over tighten).
[For ease of further assembly allow upper base ends to go
all the way down until table is complete then adjust the table
to your desired height setting.]
Fastener Parts Needed for this Step : 20 = 2 ea.
24 = 2 ea.
Attach Drawer Supports (Part ) to the left Upper Base
End (Part ).
- Insert 6x45mm bolt (Part ) on inside of the Upper Base End.
- Slide on Drawer Support (Part )
- Secure in place with Drawer Support Rod (Part ) using the
Allen Wrench (Part )
- Complete Drawer Support assembly by securing with 6x25mm
Bolt (Part )
Repeat process with second drawer support!
25
2
25
2
20
2
10
10
10
8
23
24
8
24
20
4
10/2011 - RPI