Martin Universal Design U-DS92STB Ashley Table with Stool - Manual (Page 5)

Step 7: Media Support
Step 8: Board Brace
Fastener Parts Needed for this Step : 27 = 2 ea.
18 = 2 ea.
- Attach Media Support (Part ) to upper portion base end
Insert 6x40mm bolts (Part ) through the 2 holes on the
right side of the upper base end.
- Place the media support (Part ) on the 6x40mm bolts
(Part )
[Make sure the media support is facing up like a fishing hook L]
- Secure with nut (Part )
- Secure with wrench (Part ) & Allen wrench (Part )
Fastener Parts Needed for this Step : 21 = 10 ea.
Note: Lay the Table Top (Part ) onto a flat-carpeted
surface to avoid scratching the tabletop.
You will also need a Phillips head screwdriver.
*** Some of the holes are not pre drilled ***
Locate the set of pre drilled holes & place the Board Brace
(Part ) between the holes.
Make sure board brace has the holes facing parallel to the table
top so you can see through them and not into the tabletop.
18
18
22 23
27
18
27
9
9
9
9
27
27
Now place the Board Brace Clamps (Part ) over the Board Brace (Part ) on the
backside of the Table Top (Part ) and line up the Board Brace (Part ) with two of
the pre drilled holes.
You will have to screw in two of the holes into non-predrilled spots using self tapping
4x12mm screws screws (Part ).
All you have to do is keep turning and push down a little and the screws will tap and
thread themselves.
Tighten the 4x12mm screws (Part ).
Note: Secure these screws and then loosen a quarter turn. This allows for the tabletop
to move easily when making a tilt adjustment later on.
Repeat process with second board brace clamp.
1
1
7
7
7
7
7
13
13
13
13
21
21
21
21
21
1
5
10/2011 - RPI