Martin Universal Design Manchester Split-top Table - Manual (Page 9)

After lining up holes, attach tilt mechanism (Part J) to
top with 2 each 6x8mm Hex Bolts (Part P). Tighten with
Allen Wrench. See FIG 15.
STEP 11] Attach Tilt Mechanism to Top
Pg. 9
May 08- RPI
Attach the 2 Hinges (Part M) to the top by using 3 each
4x12mm screws (Part S) per hinge. Tighten with
phillips screwdriver.
See FIG 16.
STEP 12] Attach Hinges to Top
WARNING:
Turn table upright with TWO PEOPLE - DO NOT ATTEMPT to turn assembled table
onto its legs with only one person. Then continue with assembly
Manchester Split-top Table Assembly Instructions
PLEASE NOTE:
Before attaching Drawer Stop (Part X), the Drawer
must be installed FIRST!
To do so, slide drawer onto drawer glides
See FIG 17.
STEP 13] Attach Drawer Stop
FIG 15
FIG 16
FIG 17
J
M