Martin Universal Design Avanti Print Rack Assembly - Manual (Page 2)

Assembly continued:
Step 3:
Take the 1 of the leg assemblies and lay it down flat
on a flat surface. Making sure the oval slots are
facing upward. Attach the Material Shelf (H) by
inserting one end of it into the lower slots of the leg
assembly. You may need to pound the tray down
into the slots by using a rubber mallet. PLEASE
NOTE: Legs may need to be slight adjustment to fit.
Secure by inserting (2) 1-3/4” Hex Nuts (F) into the
opposite side holes. Finger Tighten. SEE FIG 2.
Step 4:
Attach other leg assembly by inserting end of mate-
rial shelf (H) into lower oval slots of leg assembly.
Secure by inserting (2) 1-3/4” Hex Nuts into the
opposite side holes. Finger Tighten.
Step 5:
Stand rack assembly upright onto its base legs.
Insert all 4 flat spindles (D) into their respective slot
holes on edge of material shelf. You may have to
work the spindle in a back-in-forth motion while
applying pressure to get the spindle in the slot hole.
This tightness is for durability. SEE FIG. 3
Step 6:
Attach (2) Cross Members (C) by inserting one end
of cross member into one side of leg assembly, then
proceed to move across to the flat spindles (D) and
then to the other end of leg assembly. By following
this order, the cross member is easier to attach.
Make certain logo on Cross Member (C) is on out-
side edge. Secure by inserting a 1-3/4” Hex Bolt into
each end of leg assembly. Tighten. Repeat with
other side. SEE FIG. 4
Step 7:
Return to all Hex Bolt connections and tighten to
secure.
Your Print Rack is now ready for years of use.
FIG. 2
(B)
(A)
(F)
(H)
FIG. 3
Logo Position on
Cross Member
(C)
(D)
(H)
(A)
(B)
(D)
(H)
(A)
(B)
FIG. 4
(F)
Martin/F. Weber Co.
4444 Lawton Avenue, Detroit, MI 48208 USA