Barksdale BPS3000 - Manual (Page 4)

7.1 Parameters
Parameter 14-segment display Description
SP1/SP2*
/
Hysteresis function: Switching point of solid state contact
FH1/FH2*
/
Window function: Window High solid state contact
rP1/rP2*
/
Hysteresis function: Hysteresis of solid state contact
FL1/FL2*
/
Window function: Window Low solid state contact
EF Extended programming functions
rES Reset parameters to factory settings
dS1/dS2*
/
Switching time delay – the set contact rating must be
permanently exceeded to trigger a switching function
dr1/dr2*
/
Switching time delay – the contact rating must be
permanently lower than the set contact rating to trigger a
switching function
Switching function of solid state contact
HNO = Hysteresis function, NO contact
HNC = Hysteresis function, NC contact
FNO = Window function, NO contact
FNC = Window function, NC contact
Ou1/Ou2*
/
DIA = Diagnostic function, NO contact (only Ou2)
uni Select unit: bar, PSI, MPa
If the measuring range is outside the display range, unit
selection is impossible. The parameter "uni" is not
displayed.
Analog output
I = 4... 20 mA
U = 0... 10 V
I.INV = 20... 4 mA
OuA**
U.INV = 10... V
ASP** Analog start value
Parameter 14-segment display Description
AEP** Analog end value
dPA** Damping of analog output
ErS.A** Error signal of analog output
Values: < 3.6 or > 22 or Off
Hi Saved value of highest pressure measured
Lo Saved value of lowest pressure measured
COF Offset correction (max. 10 % of measuring range)
ddis Damping display
Fdis Rotate display through 180°
LocK Locking feature
* only models with 2nd switching contact
** only models with analog output
Error list
Parameter 14-segment display Description
sens Sensor defect
SC1 Short circuit, solid state contact 1
SC2 Short circuit, solid state contact 2
AOut Open output, short circuit
OL Sensor limit positive
UL Sensor limit negative
KEY Internal defect
7 6