ArtDio SS-200 - Manual (Page 3)

5 4
(1) Call Button & LED ( support Skype only )
Make a Call: Press to make an outgoing call.
Answer a Call: Press to answer an incoming call.
Disconnect a Call: Press to disconnect a call.
Green LED will flash when a call is ringing, it will light when the call is
connected.
(2) Microphone Mute & LED
Press to mute the microphone, the blue LED will light.
(3) Built-in Microphone
Talk directly with the built-in microphone on the speaker to enjoy your
conversation hands free.
(4) 3-Port High Speed 2.0 Hub & LED
Provides connectivity of up to 3 USB peripherals and devices simultane-
ously. The total power input for the USB Hub is 5V DC, maximum 600mA.
Orange LED will flash when a USB device is connecting to the USB port, it
will light when the USB device is powered and ready to use.
NOTE: When the SS-200 speaker is connected to the computer, do not connect additional USB audio
devices such as ArtDio’s SS-168 or SS-100, and any other USB audio devices to the computer.
CONNECTION
1.Connect the mini USB connector to the mini USB jack located on the bottom
left panel of the speaker.
2.Plug in the USB cable from the speaker to the USB-port on your computer.
3.The red LED will light to indicate the power for SS-200 speaker is on.
4.Flip the speaker stand all the way to the back of the speaker, and place it on a
flat sturdy surface to stand.
(5) Power LED
Red LED will light to indicate the speaker is connected properly to the
computer, powered and ready for use.
(6) 2.5mm Headphone Jack
Connect to headphone with 2.5mm connector for private conversation.
Note: A mono headphone with built-in microphone is included.
(3)
(4)
(5)
(6)
(2)
(1)
CONTROLS
(please refer to picture [A])
picture [A]