Brocks Performance Radial Mount Strap Bracket S1000RR (10-14) User Manual
Page 2
DOCUMENT ID 992495
PAGE 2 of 2
INSTALL STRAP
Always route strap under any cables and
wires to prevent pinching or damage. Do
not allow the strap to twist.
On each side
of the frame at the steering neck are zip
ties securing wiring to clips, cut the zip ties
to release the wires from the clips and
place zip ties around the wires only. Install
the release buckle on the left side of the
bike (while seated) using the M10x25 bolt
and serrated washer. Hand tighten. Route
the strap upward over the steering neck
and down the other side. Secure the
remaining end of strap with the M10x20
bolt and serrated washer. Tighten strap to
align the ends and torque the M10 bolts to
38 Nm (28 lb-ft).
OPERATION
To lower front end: Apply moderate
pressure to front brake lever, lunge
forward to compress front forks while
simultaneously pulling upward on strap
handle.
Attention: BIKE MAY FALL OVER!
Short kickstands are required when bike is
lowered. Contact Brock’s Performance for
details.
DANGER: Strap handle MUST be securely
fastened.
A loss of control can occur if the
strap handle becomes tangled in the front
wheel or brake assembly. Brock’s
Performance supplies reusable zip ties to
secure the handle in a safe location.
To raise front end: Press release on the
buckle.
Brocks Performance Products are designed for Closed-Course Race Track use ONLY.
Brocks Performance Products policies and warranty information:
www.BrocksPerformance.com
For additional information: Check our Information Forum at
www.BrocksPerformance.com
or call the Order Line 937-912-0054.
PRESS TO
RELEASE