Apogee Digital X-HD - Manual (Page 25)

APOGEE ELECTRONICS
15
X-HD card – User’s Guide
Installing the X-HD Card
Your X-HD card should include the following:
1 X-HD circuit board
1 X-HD Coverplate
2 aluminium standoffs
1 plastic standoff
2 screws
1 manual
1 Remove the top cover of the interface
2 Remove the Option Card coverplate and install the X-HD
coverplate using the screws from the original coverplate.
3 Remove the two interface circuit board screws indicated
at left, and set them aside for later use
4 Install the two aluminium standoffs in the threaded holes va-
cated by the screws.
5 Install the plastic standoff in the hole adjacent to the
connector pins of the X-HD card.
6 Insert the Primary/Expansion ports connector end of the
X-HD card through the appropriate cutouts in the coverplate,
and carefully place the X-HD connector pins in the mating
interface connector.
7 After verifying the alignment of the X-HD connector pins
and the interface mating connector, firmly press down on the
X-HD card, over the connector, until the pins are completely
seated in the mating connector.
8 Secure the Primary/Expansion Port connectors to the
Coverplate by installing the 2 provided screws into the 2 inner
threaded holes
9 Re-install the circuit board screws in the locations indicated
below.
2
9
6
Plastic standoff here
3
4
8