Rugged Ridge XHD Bracket Conversion Kit For JK 2012 - Manual

11540.10
Jeep
®
JK Wrangler Modular HD Front Winch Bumper
Contents:
1. Bumper Center Section (1)
2. Right Stubby End (1)
3. Left Stubby End (1)
4. D-Ring (2)
5. M12 x 60 Bolt (8)
6. M12 Washer (22)
7. M12 Lock Nut (14)
8. M3 Lock Nut (8)
9. M3 Washer (8)
10. M8 Washer (8) *
11. M8 x 20 Bolt (8) *
1. Disconnect fog lights by twisting the plug in the rear of them. Remove 4 nuts per frame horn that hold
the original front bumper to the vehicle. Remove original bumper.
2. Install the original fog lights into the Center Section from the back (Figure 2a). Use the (8) M3 lock
nuts and M3 washers to secure them (Figure 2b).
Page 1 of 4
Figure 2a Figure 2b
1
8
3
6
5
4
7
2
11
* Note - These components are only used when installing top mounted add-on pieces.
9
10