Rugged Ridge XHD Bracket Conversion Kit For JK 2012 - Manual (Page 3)

Page 3 of 4
7. Once all 4 Winch bolts have been started, tighten them.
8. Place Center Section of Bumper onto the frame rails and then install the 12mm bolts (8), 12mm
washers (8), D-Rings (2), more 12mm washers (8), and 12mm Lock Nuts. Don't tighten any of the
fasteners yet. When installing D-Rings, note that the holes that are further apart should be on top.
Note - If installing Stinger (11540.13) or RRC Hoop (11540.18) D-Rings will not be used.
See instructions for those products at this point.
9. Tighten (8) bolts that were installed in Step 8.
M12 Bolt
M12 Washer
D-Ring
Frame Horn
M12 Washer
M12 Lock Nut