Rugged Ridge CB Radio Mount, 07-14 Jeep Wrangler (JK) User Manual
07+ jk cb mount, Notice, Components: required tools
Copyright © 2013 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
07+ JK CB Mount
2. For 2007-2010 model JK’s: drill out rivets using
3/8” drill bit. Rivets will be replaced with Well Nuts.
3. For 2011+ model JK’s: remove center footman
loop by removing (2) Torx Screws.
1. CB Mounting Bracket
(1)
2.
M5
Well
Nut
(2)
3. M5x20 Philips Head Machine Screw
(2)
4. M5x12 Philips Head Machine Screw
(2)
5. M5 Locking Hex Nut
(2)
1. #2 Philips Head Driver
2. T-25 Torx Driver, or T-15
Torx Driver
3. 3/8” Drill Bit
4. Drill
1. Position sun visors against side windows. Remove
center portion of plastic windshield frame cover by
gently pulling down until the clips release.
Page 1/2
11503.95
Components:
Required Tools:
OMIX-ADA
®
TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Read all instructions thoroughly before installation.
Rev 09/2013
Be careful not to drill too deep, you may
damage other side of windshield frame.
NOTICE