Rugged Ridge CB Radio Mount, 07-14 Jeep Wrangler (JK) - Manual (Page 2)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
07+ JK CB Mount
7. Replace center plastic windshield frame cover.
Install CB Mount, radar dectector, or GPS device
using M5x15 bolts and Locking Hex Nuts.
5. For 2007-2010 model JK’s: use provided M5x20
screws to install CB Mount and footman loop with
CB Mount on outside.
6. For 2011+ JK’s: use factory Torx screws to install CB
Mount and footman loop with CB Mount on outside.
4. For 2007-2010 model JK’s: insert Well Nuts into
newly drilled holes in sheet metal. If drilled holes are
too large to snuggly fit Well Nuts, secure with small
amount of super glue.
Page 2/2
11503.95
Make sure any installed devices are se-
cure, and safe. Do not obstruct rear view
mirror. NOTICE