Avaya 2600 - Manual (Page 6)

TMA; Reviewed:
SPOC 7/21/2008 Solution & Interoperability Test Lab Application Notes
©2008 Avaya Inc. All Rights Reserved.
6 of 21
ProCurve-ACM
All network components are in network region 1 for this sample configuration. The DiffServ and
802.1P/Q values configured here will be downloaded to the Avaya H.323 IP telephones via
Avaya Communication Manager. Avaya SIP IP telephones will get QoS settings by downloading
the 46xxsettings file from the HTTP server. For more information on QoS settings, please refer
to [1].
Use the change ip-network-region 1 command to change the DIFFSERV/TOS PARAMETERS
and 802.1P/Q PARAMETERS settings configured in Avaya Communication Manager. Set the
Call Control PHB Value to 46 and the Audio PHB Value to 46. Set the Call Control 802.1p
Priority and Audio 802.1p Priority to 6.
change ip-network-region 1 Page 1 of 19
IP NETWORK REGION
Region: 1
Location: Authoritative Domain: devcon.com
Name:
MEDIA PARAMETERS Intra-region IP-IP Direct Audio: yes
Codec Set: 1 Inter-region IP-IP Direct Audio: yes
UDP Port Min: 2048 IP Audio Hairpinning? y
UDP Port Max: 3027
DIFFSERV/TOS PARAMETERS RTCP Reporting Enabled? y
Call Control PHB Value: 46 RTCP MONITOR SERVER PARAMETERS
Audio PHB Value: 46 Use Default Server Parameters? y
Video PHB Value: 26
802.1P/Q PARAMETERS
Call Control 802.1p Priority: 6
Audio 802.1p Priority: 6
Video 802.1p Priority: 5 AUDIO RESOURCE RESERVATION PARAMETERS
H.323 IP ENDPOINTS RSVP Enabled? n
H.323 Link Bounce Recovery? y
Idle Traffic Interval (sec): 20
Keep-Alive Interval (sec): 5
Keep-Alive Count: 5
The Differentiated Services Code Point (DSCP) value of 46 is used for both PHB values. DSCP
46 represents the Traffic Class of Premium and the Traffic Type Voice.
Note: The PHB and DSCP values used above (i.e. 6 and 46) will be used consistently throughout
the configuration of the ProCurve switches. The DSCP value used above is in decimal whereas
the value used for ProCurve switch configuration later will be in binary (i.e. 101110).
5. Configure the ProCurve 5406zl Switch
This section addresses how to configure the ProCurve 5406zl Switch. The ProCurve 5406zl
Switch is used as the core Layer 2/Layer 3 router, enforces QoS policies and supports link
aggregation, OSPF and spanning tree.
To configure the ProCurve 5406zl Switch, connect a PC or laptop to the serial port of the
ProCurve 5406zl Switch. Run a terminal emulation program with the following configuration:
ƒ Bits per second: 9600
ƒ Data bits: 8
ƒ Parity: None
ƒ Stop bits: 1
ƒ Flow Control: None