Mittler Bros Machine & Tool 400-VSUADJ - Manual (Page 10)

- 10 -
TWO SIDED NOTCH OPERATION
Requires Model #400-S2 or Model #400-VS2
Front Side Notch Cluster Joint Back Side Notch
Front Side Notch – Follow Instructions on Pages 5 – 7.
Back Side Notch -
1. Turn In/Out Handwheel counterclockwise to move tube away from cutter.
2. Adjust cutter speed to slowest speed.
NOTE: Allows cutter holding setscrews to be properly positioned to remove cutter.
3. Turn OFF Cutter switch.
4. Remove Cutter for clearance to move vise to back side
NOTE: Tube can remain clamped in vise to hold proper 2-side notch alignment.
5. Turn In/Out Handwheel clockwise to move vise assembly to Back Side.
6. Install Cutter & Tighten Cutter Holding Setscrews.
7. Rotate Vise to proper angle for desired notch and tighten vise holding nuts.
8. Relocate Chip Tray so positioned under Cutter – see picture below.
9. Place tubing in vise and tighten vise jaws to hold tubing – if tube was removed.
10. Turn ON Cutter switch.
11. Adjust Cutter Speed to proper speed for tubing thickness to be notched.
12. Turn
Back Side In/Out Handwheel clockwise to make desired notch.
Chip Tray Mount Chip Tray