Mittler Bros Machine & Tool 400-VSUADJ - Manual (Page 27)

- 27 -
4.
Set the Ultimate notcher onto the stand using a hoist and a pair of slings as outlined below. The On / Off switch and /
or control panel should be on the same side of the stand as the cutter holder holes on the middle shelf.
BE EXTREMLY CAREFULL WHEN MOVING THE NOTCHER ASSEMBLY, UNIT WEIGHS
ALMOST 400 LBS.
5.
Once the notcher is setting on the stand line up the mounting holes in the machine base plate with the holes in the
stand. Use the 3/8” x 4” hex bolts on the front side and the 3/8” x 1-3/4” hex bolts on the back side. Use the supplied
washers under the bolt heads and use the lockwashers on the nut side.
Thank You for Your Purchase.
We appreciate your business.
Using A Hoist
Cutter Holder Holes
4” Bolts in Front 4” Bolts in Front
1-3/4” Bolts on Back Side
Lock Washer &
Nuts on Bottom
Flat Washer &
Nuts on Top.
This Bolt Only,
Put Bolt In
From Bottom