Australian Monitor HA6 - Manual (Page 4)

F R O N T & R E A R PA N E L
PAG E 4 A M I S H A 6 I N S TA L L AT I O N & O P E R AT I O N M A N UA L
REAR PANEL
LEVEL
This pot controls the level of the output signal of
the corresponding channel.
OUTPUT
A 6.35mm stereo socket provides connection for a
headphone. The level is controlled by the
corresponding channel LEVEL pot.
POWER ON LED
This indicates there is power to the unit.
1 2 3
1 2 3
STEREO INPUT
There are 3 parallel inputs for connecting
sources to.
XLR input - These are balanced line level inputs for
left and right.
RCA input - These are unbalanced line level inputs
for left and right.
6.35mm Jack - This is for a TRS 6.35mm (1/4”)
plug. Left is on the tip and right is on the sleeve.
VOLTAGE SELECT SWITCH
This switch is used to select the mains voltage for
your region.
WARNING: Check that this switch is in
the correct position for your region
before turning on the device. Operating
this equipment with the wrong setting
may result in damage to the unit.
IMPORTANT: Disconnect power to the
amplifier before operating this switch.
IEC MAINS INPUT SOCKET
This is a standard IEC 3 pin socket. It accepts a
standard IEC mains cable, provided. The fuse draw
contains the mains fuse and a spare. The mains
fuse is a time lag (slow blow) HRC 20mm x 5mm
ceramic type fuse.
The ratings are:
230V/240V model: 63mA
115V model: 125mA
IMPORTANT: Always replace the fuse
with one of the same value and type.
NOTE: Always disconnect power to the
HA6 before replacing fuses.
1 2 3
1 2 3