Australian Monitor MX82 User Manual
Page 5
R E A R PA N E L
PAG E 5
M X 8 2 I N S TA L L AT I O N & O P E R AT I O N M A N UA L
CHANNEL INPUTS
Channels 1 to 4 are mic/line switchable XLR balanced inputs. It accepts mic
or line level signals depending on the gain switch position. The XLR will
also have +15V phantom power if selected on the switch accessed through
the lid, see Internal Adjustments.
DIRECT OUT
A unique feature of the MX82 is the individual direct output available for
each of the first 4 channels. The direct outputs are accessed via balanced
TRS 1/4” sockets for each channel. The level of each output is
0dBu (nominal). The signal from any of the four channels can be
disconnected from the main left/right outputs, see Internal Adjustments.
The direct outputs are adjustable to be pre or post the channel level control,
see the Internal Adjustments.
STEREO CHANNEL INPUTS
Channels 5 to 8 are stereo line level RCA unbalanced inputs.
REC OUT
The REC OUT output is on unbalanced RCA connectors. The output is not
affected by the MASTER volume control.
LEFT AND RIGHT OUTPUT
The OUTPUT XLR’s provide balanced line level signal of the left and right
bus respectively.
NOTE: When wiring the LINE output as unbalanced, Pin2 should be
wired as hot and Pin1 should be wired as ground/shield.
Do not wire Pin3.
IEC MAINS INPUT SOCKET
This is a standard IEC 3 pin socket. It accepts a standard IEC mains cable,
provided. The fuse draw contains the mains fuse and a spare. The mains
fuse is a time lag (slow blow) HRC 20mm x 5mm ceramic type fuse.
The ratings are:
230V/240V model:
63mA
115V model:
120mA
IMPORTANT: Always replace the fuse with one of the same value
and type.
NOTE: Always disconnect power to the amplifier before
replacing fuses.
OPTIONAL MODULE INPUTS
This socket is used with a tone module and/or VCA module.
1
2
3
4
5
6
7
4
6
2
1
3
5
7