Australian Monitor BGM2TCD - Manual (Page 6)

PAG E 6
B AC K PA N E L
DIRECT STEREO OUTPUTS
These outputs provide direct signal from
the modules.
PRIORITY
The BGM2 features a STEREO PRIORITY
OUTPUT, in addition to the separate Direct
Stereo outputs for the modules. The
Priority Output will output the signal from
the secondary module until signal appears
on the primary module.
BGM2-DCD: CD2 has priority over CD1
BGM2-DT: TUNER2 has priority over
TUNER1
BGM2-TCD: CD has priority over TUNER
Signal from the secondary module will
return automatically, once the primary
module falls silent.
This feature allows the user to utilize only
one input on their mixer/amplifier for both
modules.
ANTENNA
These terminals provide connections for
the antenna of each band. There will be
two strips of terminals on the BGM2-DT,
one for each module.
IEC MAINS INPUT SOCKET
This is a standard IEC 3 pin socket. It
accepts a standard IEC mains cable,
provided. The fuse drawer contains the
mains fuse and a spare. The mains fuse
is a time lag (slow blow) HRC 20mm x
5mm ceramic type fuse.
The ratings are:
230V/240V model 630mA
115V model 1.2A
Left side - Back Panel
Right side - Back Panel
B G M 2 P R O G R A M S O U R C E S E R I E S I N S TA L L AT I O N & O P E R AT I O N M A N UA L
Always replace the fuse with one
of the same value and type.
NOTE: Always disconnect
power to the amplifier before
replacing fuses.
1 3
2
4
2
1
4
3