Australian Monitor My Music - Manual (Page 4)

PAGE 2 MY MUSIC PROGRAM SOURCE SERIES INSTALLATION & OPERATION MANUAL
FRONT PANEL – CD/USB PLAYER
7 9 10 11
12
13
1 4 5 6
14
2 3
8
1 POWER
Turns the My Music player on or off.
2 PROG
Works with conventional CD’s only, does not apply to
MP3 recorded disks.
Allows you to program up to 20 tracks to play in the
order you program. The program order is not saved
and will be cleared when you press STOP. Use the UP/
DOWN buttons to change track and press PROG to
move to the next program slot. Press PLAY/PAUSE to
start the program order. REPEAT ALL will repeat the
order that has been programmed. While in program
mode, “Pxx” on the LCD display indicates the program
order position. While in program play mode, “Pxx”
on the LCD display indicates the actual track number.
An ordered program cannot be paused. Advance the
program order using UP/DOWN. Once an order position
(“Pxx” in program mode) has been entered it cannot be
changed. Pressing PROG while the track indicator reads
“–“ cycles you through the program order. Selecting UP/
DOWN changes the track number but pressing PROG
again will put that track in the next program position.
3 SKIP REV/CUE
Pressing these buttons momentarily changes the track.
Pressing and holding these buttons while a track is
playing changes the position within a track. Note that
audio is not audible while changing track position.
4 STOP
Stops the CD/MP3 playing and returns to the start of
the disk. This button also clears the programmed track
order.
5 PLAY/PAUSE
Plays and pauses the track.
6 EJECT
Ejects the disk. Pressing this button while a disk is
ejecting returns the disk to the player.
7 REPEAT
Will cycle though the repeat functions of the unit.
8 FOLDER FWD REV:
For use when playing MP3 (data) CDs, or USB memory
sticks. Jumps to either the next availalble folder, or
previous folder. Moves sequentially through folder tree
structure.
9 A-B:
Pressing the A button will set a start point and B will
set an end point. Once this has been done, a loop
will cycle between these two points.
10 MUTE
Mute’s the Audio
11 FUNC:
Cycles the unit between CD Player, Mp3 Player and
SD Card player
12 SD/MMC
Card Slot
13 CD PLAYER
This slot is for loading either audio CDs or data
CD-ROMs with MP3 fi les pre-loaded.
14 USB STICK INPUT
This socket is for connecting a USB memory stick with
MP3 audio fi les pre-loaded.
CD/USB/SD PLAYER