Australian Monitor My Music - Manual (Page 6)

PAGE 4 MY MUSIC PROGRAM SOURCE SERIES INSTALLATION & OPERATION MANUAL
SPECIFICATIONS BACK PANEL
DIRECT STEREO OUTPUTS
These outputs provide direct signal from each module.
PRIORITY
The My Music MYM-TCD features a STEREO PRIORITY OUTPUT, in addition
to the separate Direct Stereo outputs for the modules. The Priority Output
will output the signal from the secondary module until signal appears on the
primary module.
MYM-TCD: CD has priority over TUNER
Signal from the secondary module will return automatically, once the primary
module falls silent.
This feature allows the user to utilize only one input on their mixer/amplifi er
for both modules.
ANTENNA
These terminals provide connections for the antenna of each band.
There will be two strips of terminals on the MYM-DT, one for each module.
There is no antenna connection for the MYM-DCD.
IEC MAINS INPUT SOCKET
This is a standard IEC 3 pin socket. It accepts a standard IEC mains cable,
provided. The fuse drawer contains the mains fuse and a spare. The mains
fuse is a time lag (slow blow) HRC 20mm x 5mm ceramic type fuse.
The ratings are:
230V/240V model 0.63mA
115V model 1.25A
Mains connected apparatus covered by this standard is intended for installation
in compliance with the National Electric Code ANSI/NFPA 70.
Always replace the fuse with one of the same
value and type.
NOTE: Always disconnect power to the amplifi er before
replacing fuses.
5
RS232:
This is a DB9 socket for RS232 control. The pin out is:
Pin 2 = TX
Pin 3 = RX
Pin 5 = GND
1
2
3
4
1
2
3
4
Left side – Back Panel
Right side – Back Panel
NOTE: The above drawing shows the back panel of the 115V
version. Layout is similar for the 230V version.
Correct mains voltage should be noted on the actual unit.
5