Rivera Primo Brute III Extreme 2007 Enclosed Belt Drive - Manual

B R U T E I I I E X T R E M E 2 0 07
TM
E N C L O S E D B E LT D R I V E
I N S TA L L AT I O N I N S T R U C T I O N S
I
t is common knowledge that a belt drive primary provides advantages & service that a standard chain drive
primary cannot. For dependable, high-performance, long lasting service nothing beats a modern Primo ® pri-
mary Belt Drive! A long standing tradition of ”Quality & Performance” has made Primo ® Belt Drive systems
the most popular in the world! That same quality & performance is now available in the Brute III EXTREME
2007 TM belt drive for ‘06 Dyna ® & ‘07 Later Softail ® motorcycles (fully enclosed primary drive). The wet clutch
nightmare is over, no more leaky primary, no more draining the primary for inspection or maintenance. Carefully
read & follow these instructions for a quick, convenient installation. If you have questions call (562) 907-2600.
IMPORTANT SAFETY NOTICE....
When performing any motorcycle work such as installing a belt drive, secure the motorcycle in an upright position
with convenient access to the primary drive. If you are working with the motorcycle on a lift make sure it is securely
fastened to prevent it from falling.
REmOvE ThE baTTERy pRiOR TO sTaRTiNg This iNsTallaTiON.
Drain the primary case, remove both the inner & outer pri-
mary covers, & all OEM chain drive components from the
primary chaincase. Thoroughly clean the inner & outer pri-
mary covers to re-
move all traces of
primary fluid. Remove
the factory bearing
race from the trans-
mission
mainshaft
using the Jims tool
part # 34902-84.
(Shown is a 2007
H a r l e y - D a v i d s o n
®
Softail ® ).
1 2
Install the sealed bearing Strip the primary
Install Primo’s one-piece, sealed bear-
ing included in the kit.
NOTE:(Use 1018-0021 for 2007 models
and 1018-0028 for 2008 & later models).
2108-0026
11mm 1 3/4” Wide
Fits 2007 up Softail
®
Models
&
2006 up DynaGlide ® Models
Page 1
NOTE: On all
2007 and many
2008 models it
will be necessary
to replace the OE
stator rotor with
OE stator rotor
part # 30041-08.