Rivera Primo Brute IV - Manual (Page 6)

16
17
18
DO NOT OPERATE
this or any other Rivera Primo Inc. open-primary belt-drive without the proper safety guard or belt cover in place. A well designed
belt guard actually adds to the appearance of the motorcycle while protecting you as well as the belt drive from incidental
damage caused by rocks or debris between the belt and the pulleys. Be safe, always use a belt guard!
Y O U R A T T E N T I O N P L E A S E ! !
STEP 16:
TIGHTEN THE SHOULDERED NUTS
EQUALLY UNTIL THEY BOTTOM, AND
THEN TIGHTEN TO 30 INCH POUNDS
(NOT FOOT POUNDS) OF TORQUE.
Install the clutch adjustment screw &
adjust the clutch following factory proce-
dures as found the Harley-Davidson ser-
vice manual. Bend the lock tabs over to
prevent the nuts from coming loose.
Note: Never use Loctite on these threads
STEP 17:
Install the starter support housing (over the starter extender
mechanism) as pictured. Carefully locate the housing to align
the bolts. Check to make sure the starter can turn freely as the
bolts are tightened. TORQUE TO 29 FOOT POUNDS.
STEP 18 & 18A
This is what your installation should look like.
Be sure & install either the belt guard that
came with the kit, or one of Rivera Primo
Inc.’s optional belt guards.
To check belt tension grasp the top belt and
move up and down. It should have approxi-
mately 3/4” of total movement with a cold
drive train.
18A
A belt guard is included with all Brute IV TM kits.
Using one(1) drop of “red” threadlock or equivalent
on each fastener, bolt the belt guard to the stand-
off studs using the supplied 5/16” buttonheads &
TORQUE TO 29 FOOT POUNDS.
6