Rivera Primo 1116-0400 H4 LED REPLACEMENT BULB - Manual (Page 2)

12.
Twist LED & cooling unit into headlamp housing.
13.
Plug included wire harness into bottom
of the LED/cooling unit.
14.
Plug LED harness into stock 3 prong connector.
15.
Replace the headlamp housing into
the headlight bucket.
Note:
The 1116-0401 will not work with an internal tri bar lens.
Note:
Once the harness is plugged in do not remove.
11.
Insert the LED/cooling unit into the headlight housing.
10.
Center the L shaped groove on LED/cooling unit
with the two grooves on the protective shield.
1108-0029