Alto-Shaam PLATINUM SERIES ASC-2E - Manual (Page 16)

o P E R A t I n G I n S t R U C t I o n S
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 14
PROgRaMMINg
This Alto-Shaam electronic convection oven allows the operator
to program up to seven cooking procedures. Each cooking
program entered can be preset in any program function to cook
by time (or probe, if a probe is included on the oven). Cooking
programs are stored and recalled with M, the PRESEt keys
labeled “1 through 7.”
Press MaIN POwER Q “on.”
• The display 2 will alternate between last Cook Set
Temperature and actual cavity temperature. The oven will
begin preheating and the Preheat Indicator 1 will illuminate.
The fan will operate at high speed “fnhi”
follow inStruCtionS liStEd on thE
prEviouS pAgES of thiS mAnuAl
.
Press and hold selected PRESEt key 1 through 7 for 4 seconds
• A beep sounds.
• The numbered key program indicator light will illuminate.
The programmed procedure is now stored in memory for the specific
number key selected. To lock PRESEt keys 1 through 7, press
PRESEt key K simultaneously with up arrow C. To unlock, press
the preset key K simultaneously with the down arrow C.
At this point, press StARt/StoP L twice. This will protect
the PRESEt in case of a power outage.
IMPORTaNT
After programming a specific product into memory on the preset
key, it is very important to make a written permanent record of
the product and the program letter assigned.
M E N u P R E S E T S
ERaSINg a PROgRaM
To erase a program, the oven must be in the PrEhEAT mode.
The oven cannot be running a PrESET Menu program.
• When the oven is in the PrEhEAT mode, press and hold both
the CAnCEl key N and the appropriate number PRESEt
key M to be erased. hold both keys until the oven double
beeps, and the program's indicator light goes out. This
indicates the program has been erased.
not
E
:
• If the oven temperature is
higher than the PRESEt
program, utilize the
Cool down mode.
• Time and Temperature have
been programmed in the
PrESET key -- they cannot
be adjusted during the
PrESET cooking cycle.
cOOk –– uSINg PRESET MENu kEyS
• Press desired PRESEt key (1 thru 7) M. Preheat will begin.
• The oven will beep when the preheat temperature has been reached.
• Load food inside the oven.
If cooking by probe, remove probe from its bracket, wipe the tip with a
disposable alcohol pad and insert probe properly into product.
• Close the
oven door.
• Press StARt.
1
2
4
5
H
L
I
P
3
6
7
O
J
Q
M
K
N