Muxlab HDMI 3x1 Switcher Kit - Manual (Page 11)

© MuxLab Inc. HDMI 3x1 Switcher Kit Installation Guide
Page 11
3.4. Installation Procedure
Verify that the distance between the HDMI 3x1
Transmitter and Receiver is
within MuxLab
specifications (see Technical Specifications). In order to
install the transmitter, please follow the steps below:
1. Connect the HDMI transmitter to the HDMI video
sources with an HDMI jumper cable.
2. Connect two (2) Category 5e (or higher) UTP cables
to the transmitter.
Note: Verify that the cables are connected straight-
through (i.e. Video to Video, DDC to DDC) and not
inverted.
To install the HDMI receiver, please follow the steps
below:
3. Connect the HDMI Receiver to the display
equipment with an HDMI jumper cable (not
included).
4. Connect two (2) Cat5e cables to the Video and DDC
connectors of the HDMI Receiver.
5. Connect the 12 VDC power supply to the receiver
and then plug the power supply into an AC power
outlet. If power is present, then the green power LED
will be ON.