Squawkbox, User manual, Important safety instructions – Attero Tech SquawkBox User Manual
Page 2
SquawkBox
User Manual
Attero Tech LLC 2014
Page i
614-00007-04
IMPORTANT SAFETY INSTRUCTIONS
The symbols below are internationally accepted symbols that warn of potential hazards with electrical products.
This symbol, wherever it appears, alerts you to the presence of un-insulated dangerous voltage inside the
enclosure -- voltage that may be sufficient to constitute a risk of shock.
This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the
accompanying literature. Please read the manual.
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with a dry cloth.
7.
Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two blades and third grounding prong. The wider blade or the
third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11.
Only use attachments/accessories specified by Attero Tech.
12.
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
13.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
14.
Unplug this apparatus during lightning storms or when unused for long periods of time.
15.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in
any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
16.
This apparatus shall be connected to a mains socket outlet with a protective earthing connection.
17.
When permanently connected, on all-pole mains switch with a contact separation of at least 3mm in each pole shall
be incorporated in the electrical installation of the building.
18.
If rack mounting, provide adequate ventilation. Equipment may be located above or below this apparatus but some
equipment (like large power amplifiers) may cause an unacceptable amount of hum of may generate too much heat
and degrade the performance of this apparatus,
19.
This apparatus may be installed in a industry standard equipment rack. Use screws through all mounting holes to
provide the best support.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.