Attero Tech Box 4 I/OP - Manual (Page 16)

VoiceBox 4 I/OP
User Manual
 Attero Tech LLC 2010 Page 12 614-00008-02
3.3.3 – Matrix Mixer Output Controls
The output section of the Matrix Mixer is split into two tabs. The first tab shows the local outputs. The second tab shows
the CobraNet outputs.
The mixer sends are colored according to the corresponding output level fader. The output faders range from -100 dB to
+12 dB.
There are also a number of complementary controls: a clipping LED, a “Mute” button, and a “Polarity Invert” button.
The meters on the CobraNet outputs show the output levels from the Matrix Mixer that are available to the network.
However, the meters on the local outputs show the levels after any output processing has been applied rather than the
direct output of the matrix mixer.
3.3.4 – Sine Wave Generator
The Test Tone or Sine Wave Generator can be used to help diagnose problems.
It is generated internally by the on-board DSP of the VoiceBox. The output of
the generator is fed into the Matrix Mixer (furthest input to the right). Above
the column is the “Sine” button which, when clicked on, accesses the Sine Wave
Control form. The form has a Gain control to set the amplitude of the signal
between -100 dB and 20 dB. There is also a Frequency control to set the
frequency of the test tone which ranges from 20 Hz to 20 kHz.
Figure 16 - Matrix Mixer Output Controls: Local (left) and CobraNet (right)
Figure 17 - Sine Wave Control Form